Allied Telesis AR400 Series 구성 방법 - 페이지 2
{카테고리_이름} Allied Telesis AR400 Series에 대한 구성 방법을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AR400 Series 6 페이지. How to set up pppoe between a linux client and access concentrator
Allied Telesis AR400 Series에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (8 페이지), 문제 해결 (5 페이지), 빠른 설치 매뉴얼 (8 페이지), 빠른 설치 매뉴얼 (12 페이지), 안전 정보 매뉴얼 (18 페이지), 방법 (8 페이지)
페이지 인쇄
Related How To Notes
You may also find the following How To Notes useful:
How To Configure Remote L2TP Tunnels
How To Configure Allied Telesis and Cisco Routers To Interoperate Over L2TP
How To Notes are available from www.alliedtelesis.com/resources/literature/howto.aspx.
An example scenario for RIP over L2TP
Our example uses two office sites that are connected via a WAN connection over the
Internet using an L2TP tunnel for security.
The setup (shown below) shows the 'Central office' and 'Remote office' routers connected,
in this case, back to back via their Ethernet interfaces (this would likely be the remote WAN
connection across the Internet, with perhaps static IP assignment from the ISPs).
Page 2 | AlliedWare™ OS How To Note: Dynamic Routing over L2TP
Central office router
192.168.1.1
RIP propogates
VLAN OSPF
PPP0 over
routes over
L2TP tunnel
L2TP tunnel
to remote router
192.168.2.1
Remote office router
VLAN 2 IP=222.222.2.1
OSPF used on
local VLAN
networks
ETH0
X PC
HUB
POWER
Eth0 IP=10.10.10.1
WAN
Eth0 IP=10.10.10.2
X PC
HUB
POWER
ETH0
OSPF used on
local VLAN
networks
VLAN 2 IP=200.200.2.1
An example scenario for RIP over L2TP
VLAN 1 IP=222.222.1.1
VLAN 1 IP=200.200.1.1
rip-l2tp.eps