Dell EMC VxFlex Ready Node 14G Schnellstart-Handbuch - Seite 4
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Server Dell EMC VxFlex Ready Node 14G herunter. Dell EMC VxFlex Ready Node 14G 22 Seiten.
Auch für Dell EMC VxFlex Ready Node 14G: Inspektionshandbuch (8 seiten)
Seite drucken
Quick Start Guide
Physical server requirements
Component
Processor
Physical memory
Disk space
Connectivity
VxFlex Ready Node Quick Start Guide
4
– One Slave MDM
– One Tie Breaker
– Minimum of three SDSs (on the same servers as the above components, or
on three different servers)
– SDCs, up to the maximum allowed (on the same servers as the above
components, or on different servers)
5-node cluster
n
– One Master MDM
– Two Slave MDMs
– Two Tie Breakers
– Minimum of three SDSs (on the same servers as the above components, or
on three different servers)
– SDCs, up to the maximum allowed (on the same servers as the above
components, or on different servers)
VxFlex OS Gateway server on a separate server, or together with an MDM or SDS.
l
Do not install the VxFlex OS Gateway on an SDC server or on an SDS on which
RFcache will be enabled.
Table 1 Server physical requirements
Requirement
One of the following:
Intel or AMD x86 64-bit (recommended)
l
Intel or AMD x86 32-bit (for Xen only)
l
VxFlex OS component requirements:
500 MB RAM for the Meta Data Manager (MDM)
l
500 MB RAM for each VxFlex OS Data Server (SDS)
l
50 MB RAM for each VxFlex OS Data Client (SDC)
l
1 GB for each physical node or Xen hypervisor
l
10 GB for VMware topologies
l
One of the following:
1/10/25/40/50/100 GbE network
l
IP-over-InfiniBand network
l
Dual-port network interface cards (recommended)
Ensure the following:
There is network connectivity between all components.
l
Network bandwidth and latency between all nodes is acceptable, according to application
l
demands.
Ethernet switch supports the bandwidth between network nodes.
l
MTU settings are consistent across all servers and switches.
l