Dell EMC VxFlex Ready Node 14G Quick Start Manual - Page 4

Browse online or download pdf Quick Start Manual for Server Dell EMC VxFlex Ready Node 14G. Dell EMC VxFlex Ready Node 14G 22 pages.
Also for Dell EMC VxFlex Ready Node 14G: Inspection Manual (8 pages)

Dell EMC VxFlex Ready Node 14G Quick Start Manual
Quick Start Guide
Physical server requirements
Component
Processor
Physical memory
Disk space
Connectivity
VxFlex Ready Node Quick Start Guide
4
– One Slave MDM
– One Tie Breaker
– Minimum of three SDSs (on the same servers as the above components, or
on three different servers)
– SDCs, up to the maximum allowed (on the same servers as the above
components, or on different servers)
5-node cluster
n
– One Master MDM
– Two Slave MDMs
– Two Tie Breakers
– Minimum of three SDSs (on the same servers as the above components, or
on three different servers)
– SDCs, up to the maximum allowed (on the same servers as the above
components, or on different servers)
VxFlex OS Gateway server on a separate server, or together with an MDM or SDS.
l
Do not install the VxFlex OS Gateway on an SDC server or on an SDS on which
RFcache will be enabled.
Table 1 Server physical requirements
Requirement
One of the following:
Intel or AMD x86 64-bit (recommended)
l
Intel or AMD x86 32-bit (for Xen only)
l
VxFlex OS component requirements:
500 MB RAM for the Meta Data Manager (MDM)
l
500 MB RAM for each VxFlex OS Data Server (SDS)
l
50 MB RAM for each VxFlex OS Data Client (SDC)
l
1 GB for each physical node or Xen hypervisor
l
10 GB for VMware topologies
l
One of the following:
1/10/25/40/50/100 GbE network
l
IP-over-InfiniBand network
l
Dual-port network interface cards (recommended)
Ensure the following:
There is network connectivity between all components.
l
Network bandwidth and latency between all nodes is acceptable, according to application
l
demands.
Ethernet switch supports the bandwidth between network nodes.
l
MTU settings are consistent across all servers and switches.
l