Dell PowerEdge 1655MC Ergänzendes Handbuch - Seite 20
Blättern Sie online oder laden Sie pdf Ergänzendes Handbuch für Server Dell PowerEdge 1655MC herunter. Dell PowerEdge 1655MC 24 Seiten. Removing a fan
Auch für Dell PowerEdge 1655MC: Hardware-Handbuch (10 seiten), Hardware-Handbuch (14 seiten)
Seite drucken
Running the PERC 4/im DOS Utility
NOTICE: You must run this utility during the first server module boot after replacing the server
module board. You must run this utility only once. If you attempt to run the utility after the
server module has booted to the operating system or if you attempt to run the utility more than
once, the utility will not function properly.
Attach the USB diskette drive to the front of the server module.
1
Insert the PERC 4/im DOS Utility diskette.
2
Turn on the server module. See Figure 1-1.
3
Enter the System Setup program.
4
Ensure that the processor, memory, and service tag information is correct.
5
The service tag should match the service tag written on the server module's handle.
If the service tag information is not correct, see "Programming the Service Tag."
Select the Boot Sequence option and ensure that the USB diskette drive in the boot
6
sequence list is Enabled.
Press <Esc> to exit the System Setup program.
7
The server module boots from the PERC 4/im DOS Utility diskette and the utility
starts automatically.
If there was a mirror, press any key when prompted to create the mirror.
8
The server module reboots.
Remove the PERC 4/im DOS Utility diskette.
9
The server module upgrade is complete.
Manually Configuring the Mirroring Mode
NOTE: Perform this procedure only if you received the message Logical drive
resynchronizing while verifying the mirroring mode and you manually
deconfigured the mirrored mode.
Turn on the server module. See Figure 1-1.
1
The following message is displayed during POST:
Press CTRL-M to start LSI logic configuration utility
1-16
Repl aci ng the S er v er Mo dule Bo ard
NOTE: If you are using console redirection, you must press <Esc><Ctrl><M>.