Dell PowerEdge 2800 Umwandlung Manualline - Seite 31

Blättern Sie online oder laden Sie pdf Umwandlung Manualline für Server Dell PowerEdge 2800 herunter. Dell PowerEdge 2800 36 Seiten. Poweredge 2800 server
Auch für Dell PowerEdge 2800: Information Update (24 seiten), Installationshandbuch (22 seiten), Handbuch (44 seiten), Hardware-Installation (14 seiten), Kurzreferenz (2 seiten), Spezifikationen (2 seiten)

Y1001bk0.book Page 29 Thursday, July 8, 2004 4:32 PM

Install the tower control panel assembly.

Using a #2 Phillips screwdriver, remove the screw that secures the I/O board to the rack

carrier.

Using a #2 Phillips screwdriver, remove the two screws that secure the LCD board to the

rack carrier.

Align the I/O board on the tower carrier.

Using a #2 Phillips screwdriver, install the screw that secures the I/O board to the tower

carrier.

Align the LCD board on the tower carrier.

NOTICE:

The system ID switch plunger is very fragile. When aligning the LCD board on the tower carrier,

be careful not to damage the system ID switch plunger.

Using a #2 Phillips screwdriver, install the two screws that secure the LCD board to the

tower carrier.

Remove the protective covering from the rack carrier plastic lens.

Slide the control panel assembly's cable through the hole in the drive tray.

Align the tabs on the control panel assembly with the slots in the drive tray.

Slide the control panel assembly toward the tower front panel until it stops.

While holding the control panel assembly in place, install the three screws (that came

with your kit) that secure the control panel assembly to the tower front panel.

Inside the drive tray, latch the control panel assembly cable clamp.

Connect the control panel assembly cable to the SCSI backplane board.

Orient the system as shown in Figure 1-16.

Reinstall the hard drives, any optical drives, and devices installed in the media bay in the

system.

NOTE:

Ensure that the hard drives, any optical drives, and devices are reinstalled into the same

positions that they were removed from. The devices should be labeled appropriately.

Connect any cables to the devices in the media bay.

Slide the drive tray backward and then rotate the drive tray release lever backward until the

drive tray is in the operational position. See Figure 1-16.

Tighten the captive screw that secures the drive tray release lever to the drive tray.

Install the painted top cover that came with your kit. See Figure 1-15.

Installing the Metal Feet and Bezel

Position the system on a flat working surface so that the system is slightly hanging over the

edge. See Figure 1-18.

Tower-to-Rack and Rack-to-Tower Conversion Guide