Dell PowerEdge 2800 Conversión Manualline - Página 31
Navegue en línea o descargue pdf Conversión Manualline para Servidor Dell PowerEdge 2800. Dell PowerEdge 2800 36 páginas. Poweredge 2800 server
También para Dell PowerEdge 2800: Información actualizada (24 páginas), Manual de instalación (22 páginas), Manual (44 páginas), Instalación del hardware (14 páginas), Referencia rápida (2 páginas), Especificaciones (2 páginas)
Imprimir página
Y1001bk0.book Page 29 Thursday, July 8, 2004 4:32 PM
Install the tower control panel assembly.
Using a #2 Phillips screwdriver, remove the screw that secures the I/O board to the rack
a
carrier.
Using a #2 Phillips screwdriver, remove the two screws that secure the LCD board to the
b
rack carrier.
Align the I/O board on the tower carrier.
c
Using a #2 Phillips screwdriver, install the screw that secures the I/O board to the tower
d
carrier.
Align the LCD board on the tower carrier.
e
NOTICE:
The system ID switch plunger is very fragile. When aligning the LCD board on the tower carrier,
be careful not to damage the system ID switch plunger.
Using a #2 Phillips screwdriver, install the two screws that secure the LCD board to the
f
tower carrier.
Remove the protective covering from the rack carrier plastic lens.
g
Slide the control panel assembly's cable through the hole in the drive tray.
h
Align the tabs on the control panel assembly with the slots in the drive tray.
i
Slide the control panel assembly toward the tower front panel until it stops.
j
While holding the control panel assembly in place, install the three screws (that came
k
with your kit) that secure the control panel assembly to the tower front panel.
Inside the drive tray, latch the control panel assembly cable clamp.
Connect the control panel assembly cable to the SCSI backplane board.
Orient the system as shown in Figure 1-16.
Reinstall the hard drives, any optical drives, and devices installed in the media bay in the
system.
NOTE:
Ensure that the hard drives, any optical drives, and devices are reinstalled into the same
positions that they were removed from. The devices should be labeled appropriately.
Connect any cables to the devices in the media bay.
Slide the drive tray backward and then rotate the drive tray release lever backward until the
drive tray is in the operational position. See Figure 1-16.
Tighten the captive screw that secures the drive tray release lever to the drive tray.
Install the painted top cover that came with your kit. See Figure 1-15.
Installing the Metal Feet and Bezel
Position the system on a flat working surface so that the system is slightly hanging over the
edge. See Figure 1-18.
Tower-to-Rack and Rack-to-Tower Conversion Guide
29