Dell EMC PowerStore Schnellstart-Handbuch - Seite 5
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Lagerung Dell EMC PowerStore herunter. Dell EMC PowerStore 8 Seiten.
Auch für Dell EMC PowerStore: Schnellstart-Handbuch (8 seiten)
Seite drucken
7. Connect the base enclosure to your switches
PowerStore T model deployments
Cable the management interface on both nodes to a management switch or network.
Note: You will require two additional network cables to complete this step.
Note: For more detailed instructions on recommended networking configurations, including how to configure PowerStore T
with top-of-rack switches, see the PowerStore Networking Guide for PowerStore T Models at
http://dell.com/powerstoredocs. Check with your network administrator to determine which ports on your switches to use.
PowerStore X model deployments
1.
Connect your base enclosure to two switches to ensure a strong layer of redundancy. Cable the Ethernet switches
together by connecting two 100GbE ports of the bottom switch to two 100 GbE ports of the top switch.
2.
Using the supplied cables, connect the network cables on node A:
a.
Port 0 of the embedded module connects to switch 1.
b.
Port 1 of the embedded module connects to switch 2.
3.
Connect the network cables on node B:
a.
Port 0 of the embedded module connects to switch 2.
b.
Port 1 of the embedded module connects to switch 1.
Note: These instructions show a minimum cabling configuration. For more detailed instructions on recommended networking
configurations, see the PowerStore Networking Guide for PowerStore X Models at http://dell.com/powerstoredocs. Check
with your network administrator to determine which ports on your switches to use.
Dell EMC PowerStore Quick Start Guide
Management Switch or
Network
Page 5 of 8