Dell EMC Unity Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Lagerung Dell EMC Unity herunter. Dell EMC Unity 9 Seiten.

1. Unpack your system

Verify that you have the following components:

2U Disk Processor Enclosure (DPE) with either 12-3.5" drive slots or 25-2.5" drive slots

❑

Rail kit, including 2 rails with 6 mounting screws

❑

2 power cables (100-240Vac)

❑

Bezel

❑

Not provided by EMC, but you will also need:

❑

• A Phillips-head screwdriver with magnetic tip

• 2 CAT 5 or better Ethernet cables

The rails are designated Left and Right and cannot be interchanged.

1. First, orient the rails. Face the front of the cabinet when orienting the Left and Right rail placement. The

front of each rail is stamped L or R.

2. From the rear of the cabinet, insert the adaptors into the holes on the rear rack channel with the rail

extended as shown in the image below.

3. Push the rail into the rear mounting holes until the spring clips snap into place on the outside of the rear

rack channel:

CAUTION

Ensure the holes on the rail line up with the holes on the cabinet. This will ensure proper alignment of the

rails. Also, check that the rails are level from front-to-back and left-to-right. Ensure you are using the same

unit markers from the front of the cabinet to the rear of the cabinet.

Watch the Unity Quick Start Installation Video:

View from rear of rack

http://bit.ly/unityinfohub

Front

Channel

Spring Clips

Adaptors

Rear

Channel

Extend rail

CL5774