Dell Networking S4048 Handbuch "Erste Schritte - Seite 17

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Schalter Dell Networking S4048 herunter. Dell Networking S4048 24 Seiten.
Auch für Dell Networking S4048: Installationshandbuch (44 seiten)

Seite drucken
Dell Networking S4048 Handbuch

Navigating CLI Modes

The Dell Networking OS prompt changes to indicate the CLI mode.
You must move linearly through the command modes, except for the end command which takes you
directly to EXEC Privilege mode and the exit command which moves you up one command mode level.

Accessing the Console

The RS-232 console port is on the right-hand side of the S4048–ON system as you face the PSU side of
the chassis, as shown in the following illustration.
Figure 9. S4048–ON RS-232 Console Port
1.
RJ-45 Management Port
2.
RS-232 Console Port
NOTE: You must have a password configured on a virtual terminal line before you can Telnet into
the S4048–ON system. Therefore, use a console connection when connecting to the system for
the first time. Before starting this procedure, be sure that you have a terminal emulation program
already installed on your PC.
1.
Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S4048–ON
console port to a terminal server.
2.
Connect the other end of the cable to the DTE terminal server.
3.
Set the default terminal settings as follows.
•
115200 baud rate (set the MicroUSB console port to 9600 baud rate)
•
No parity
•
8 data bits
•
1 stop bit
•
No flow control
Accessing the RJ-45 Console Port with a DB-9 Adapter
You can connect to the console using an RJ-45 to RJ-45 rollover cable and an RJ-45 to DB-9 female
DTE adapter to a terminal server (for example, a PC).
The pin assignments between the console and a DTE terminal server are as follows:
Dell Networking OS
17