Dell Networking S4048 Handbuch "Erste Schritte - Seite 18

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Schalter Dell Networking S4048 herunter. Dell Networking S4048 24 Seiten.
Auch für Dell Networking S4048: Installationshandbuch (44 seiten)

Seite drucken
Dell Networking S4048 Handbuch
Table 2. Pin Assignments Between the Console and a DTE Terminal Server
S4048-ON
RJ-45 to RJ-45
Console Port
Rollover Cable
Signal
RJ-45 Pinout
RTS
1
NC
2
TxD
3
GND
4
GND
5
RxD
6
NC
7
CTS
8

Default Configuration

When you install the Dell Networking OS onto your S4048–ON system, it is not configured when you
power up for the first time (except for the default host name, which is Dell).
You must configure the system using the CLI.

Configuring Layer 2 (Data Link) Mode

To enable Layer 2 data transmissions through an individual interface, use the switchport command in
INTERFACE mode.
NOTE: For detailed information about configuring Layer 2, refer to the Dell Networking
Configuration Guide for the S4048-ON System.
You cannot configure switching or Layer 2 protocols such as spanning tree protocol (STP) on an interface
unless the interface has been set to Layer 2 mode.
1.
Enable the interface.
INTERFACE mode
no shutdown
2.
Place the interface in Layer 2 (switching) mode.
INTERFACE mode
switchport
To view the interfaces in Layer 2 mode, use the show interfaces switchport command in EXEC
mode.
18
RJ-45 to RJ-45
RJ-45 to DB-9
Rollover Cable
Adapter
RJ-45 Pinout
DB-9 Pin
8
8
7
6
6
2
5
5
4
5
3
3
2
4
1
7
Terminal Server
Device
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS
Dell Networking OS