3 Day Blinds ROLLER SHADE Erste Schritte - Seite 7

Blättern Sie online oder laden Sie pdf Erste Schritte für Jalousien 3 Day Blinds ROLLER SHADE herunter. 3 Day Blinds ROLLER SHADE 8 Seiten. Continuous cord loop and link system with cassette, continuous cord loop with side channels

OPTIONAL ACCESSORIES

EXTENSION BRACKETS
Extension Brackets are used to project the shade up to 3"
from the mounting surface. Extension brackets are available
at an additional charge and are ideal if your shade must clear
an obstruction such as a sliding glass door handle or window
crank. Extension brackets require a flat vertical mounting
surface of at least ⅞ ".
To assemble and mount
• Attach each mounting bracket to an extension bracket by
using the nuts bolts and washers provided.
• Mount the extension bracket to the wall per the instructions
for an "Outside Mount", using a level and making certain
that all mounting brackets are level and project the same
distance from the mounting surface. For maximum stability,
install the screws diagonally from one another.
• Install the shade per the directions for "Shade Installation".
SPACERS
Spacers are available for use on windows with a projected
molding. They are ⅜ " thick and allow the shade to be
mounted flush with the outside edge of any standard window
molding. They are available by contacting our Customer Care
Department at 800-800-3329.
7
| Cassettes and Side Channels
HOLD DOWN BRACKETS
Hold down brackets are used primarily on shades mounted to
doors or in motor homes. There are two small holes in the end
caps. Use the pin on the hold down bracket to push through
the hole in the end cap.
• With the shade lowered to it's full length, place the pin of
each hold down bracket into the hole in each end of the
bottom rail.
• Mark the mounting surface, either to the side or back of the
window frame, through the holes in the hold down bracket.
Make sure the hold down brackets are level and aligned with
each other.
• Raise the shade and screw the hold down brackets into the
mounting surface using the screws provided.
• Lower the shade and fl ex the
hold down bracket outward
so that the pin can be
inserted into the hole in the
end cap.