Dell poweredge VRTX Handbuch "Erste Schritte - Seite 10
Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Schalter Dell poweredge VRTX herunter. Dell poweredge VRTX 30 Seiten. Server
Auch für Dell poweredge VRTX: Benutzerhandbuch (35 seiten), Freigabemitteilung (5 seiten), Handbuch "Erste Schritte (14 seiten), Schnellstart & Referenzhandbuch (2 seiten), Technisches Handbuch (45 seiten), Erste Schritte (2 seiten)
Seite drucken
- 1. Getting Started Guide
- 1. 1 Hardware and Initial Configuration
- 1. Switch Hardware
- 1. Initial Configuration of the Switch
- 2. Table of Contents
- 2. 2 Using the CLI
- 2. CLI Command Conventions
- 2. Accessing the Device through the CLI
- 2. Retrieving an IP Address
- 2. Security Management and Password Configuration
- 2. Configuring Login Banners
- 2. Startup Menu Procedures
- 2. Software Download
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
NOTE:
CLI and/or GUI need only be used if the default configuration is not
sufficient.
The switch can be configured in the following modes from the GUI:
•
Basic — Elementary network configuration for the switch.
•
Advanced — Full network configuration mode that enables configuration
of all switch capabilities. This mode is intended for advanced network
administrators.
To logon to the switch after it is inserted into the chassis, perform the
following:
1 Turn on the chassis. To display the IP address configured for the out-of-
band interface, go to the CMC GUI, options: I/O Module Overview >
Setup
2 Log on to the switch in one of the following ways:
–
Establish a Telnet session to the out-of-band IP address obtained in
the last step, and log on with the default user/password: root/calvin.
Continue managing the switch through the CLI (see "Using the CLI"
on page 11).
–
Open a GUI session from the CMC GUI, options: I/O Module
Overview > Properties > Launch IOM GUI. In the Login menu,
select either Basic or Advanced mode and use the default
user/password: root/calvin. Continue managing the switch through
the Network Administrator.
–
Connect to the IOM serial interface through the CMC. For that, use
the CMC command: connect switch. For more informations on this,
consult the
dell.com/support/manuals.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 3 / 6 / 1 3 - F O R P R O O F O N LY
10
Hardware and Initial Configuration
Plasma\GSG\Plasma_UGHW&InitialConfiguration.fm
CMC Command Line Reference
from