AVZ Twins Piazzola Installationsanweisung - Seite 3

Blättern Sie online oder laden Sie pdf Installationsanweisung für Zubehör AVZ Twins Piazzola herunter. AVZ Twins Piazzola 20 Seiten. Gastro awning

Seite drucken
AVZ Twins Piazzola Installationsanweisung
General information Twins
Maximum width
600 cm (up to projection 500 cm)
NOTE:
The aluminium support beam must always be shortened on both sides! Take the welded
sections into account when determining the width.
Total width Twins
®
Piazzola
The total system width = projection both awning + 160 mm.
Comments
Maximum fabric area 30 m² per awning section (acrylic fabric, Tibelly
•
In case of standard-size fabric, apply a free seam of 10 cm both left and right.
•
As the front profile will start to bend at a free span of 4 m, we recommend to use a tensioning
•
system.
The fabric will sag slightly at an projection of 3,5 m or more. Use additional beams to support the
•
fabric.
When using the Twins Piazzola in the rain (short light shower), we advise beam(s) to support the
•
fabric, and the use of a lockset. The Twins Piazzola should in that case be placed at a minimum
angle of 17 degrees.
Eyelets (± 50 mm from the front profile) can be placed in the fabric for better water discharge.
•
The height of the legs Twins Piazzola cannot be determined by the cut sizes as these depend on the
•
standing height, projection, protrusion of the side guide and the inclination angle.
Fabric winding method: Bottomwise
•
Foundation
•
For system stability, it is necessary to pour concrete dies for the Twins Piazzola legs with a size of 85
cm (length) x 85 cm (width) x 20 cm (height).
The legs of the Piazzola must be placed on a standard concrete pad (7700 317-068), which must be
•
poured in to create a die with a size of 35 cm (length) x 35 cm (width) x 20 cm (height).
Piazzola
Butterfly awning
®
®
®
Height legs Twins
Twins Piazzola EN 27-08-2018
Inclination angle
®
).
Page 3