AVZ Twins Piazzola Instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} AVZ Twins Piazzola. AVZ Twins Piazzola 20 pages. Gastro awning
Imprimer la page
General information Twins
Maximum width
600 cm (up to projection 500 cm)
NOTE:
The aluminium support beam must always be shortened on both sides! Take the welded
sections into account when determining the width.
Total width Twins
®
Piazzola
The total system width = projection both awning + 160 mm.
Comments
Maximum fabric area 30 m² per awning section (acrylic fabric, Tibelly
•
In case of standard-size fabric, apply a free seam of 10 cm both left and right.
•
As the front profile will start to bend at a free span of 4 m, we recommend to use a tensioning
•
system.
The fabric will sag slightly at an projection of 3,5 m or more. Use additional beams to support the
•
fabric.
When using the Twins Piazzola in the rain (short light shower), we advise beam(s) to support the
•
fabric, and the use of a lockset. The Twins Piazzola should in that case be placed at a minimum
angle of 17 degrees.
Eyelets (± 50 mm from the front profile) can be placed in the fabric for better water discharge.
•
The height of the legs Twins Piazzola cannot be determined by the cut sizes as these depend on the
•
standing height, projection, protrusion of the side guide and the inclination angle.
Fabric winding method: Bottomwise
•
Foundation
•
For system stability, it is necessary to pour concrete dies for the Twins Piazzola legs with a size of 85
cm (length) x 85 cm (width) x 20 cm (height).
The legs of the Piazzola must be placed on a standard concrete pad (7700 317-068), which must be
•
poured in to create a die with a size of 35 cm (length) x 35 cm (width) x 20 cm (height).
Piazzola
Butterfly awning
®
®
®
Height legs Twins
Twins Piazzola EN 27-08-2018
Inclination angle
®
).
Page 3