EarthWay 2600A-Plus Montageanleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Streuwagen EarthWay 2600A-Plus herunter. EarthWay 2600A-Plus 6 Seiten. 40 lb broadcast spreader
Auch für EarthWay 2600A-Plus: Montageanleitung Handbuch (6 seiten)

EarthWay 2600A-Plus Montageanleitung Handbuch
Assembly and Operation Instructions
6.
Install drive wheel to axle using pin hole nearest to lower
handles as shown. Insert 1 ¾" Cotter pin through wheel
and through axle. Bend with pliers to prevent pin from
falling out.
7. Install coast wheel to axle using outside pin hole. As
shown, add the flat washer, and insert ¾" Cotter pin through axle (not thru wheel). Bend with pliers to prevent
pin from falling out.
8. Install Handle Shaft as shown below using (2) ¼-20 x 1 ½" Hex Bolt and (2)
¼-20 Locknuts.
1
/4 - 20 Lock-nut
1 /4 - 20 x 1-1/2" Bolt
10. Attach Linkage Pivot with ¼-20 x 1 ½" Hex Bolt, Flat Washer,
Spacer and Locknut as shown below. Next, install Control Rod
into the Shut-Off Plate as shown at the right. TIP: Make sure that
the Control Rod is above the Lower Handles.
EarthWay 2600A-Plus_12-3
5.
Install the bearings over the axle and press into the notches of the lower handle as
shown to the left.
---IMPORTANT---
TURN SPREADER UPRIGHT ON TO WHEELS.
9. Insert (2) ¼-20 x 1 ½" Hex bolt
Handle Shaft
through Gauge and Linkage
Assembly, then through the Upper
Handle, Handle Shaft, Upper
Handle and secure with (2) ¼-20
Locknuts as shown to the right.
Upper Handle
1 /4 - 20 Lock-nut
/4 - 20 x 1-1/2" Bolt
1
PAGE 3