Christie Terra SCO 100 EO Handbuch für Einrichtung und Installation - Seite 13
Blättern Sie online oder laden Sie pdf Handbuch für Einrichtung und Installation für Controller Christie Terra SCO 100 EO herunter. Christie Terra SCO 100 EO 17 Seiten. Controlled systems
Seite drucken20. From the Configure Devices tab, select the Network Adapter you want to use to connect to the
Controller.
If your device has multiple network adapters, select the one that is on the same network as
the Terra Controller.
For example: if the Terra controller has an IP Address of 10.10.160.10 and your device has
two network adapters, one that is wired with an IP address of 10.10.160.50 and one that is
wireless with an IP of 192.168.0.50; the wired network adapter (10.10.160.50) would be the
one that can communicate with the Controller.
If you select an adapter and it doesn't connect, select another adapter from the list until one
connects.
21. Select the Controller; or type the IP address of the Controller and press the Enter key.
22. Review the calculated IP range, subnet, and gateway information to be assigned to TX/RX devices
and optionally make any changes.
23. Click Save.
24. Select the checkbox for the devices you want to assign IPs (this can be done individually or through
the check all checkbox (
Each TX and RX uses two IP addresses; one for video and one for USB reach back. You will need
twice the number of Terra TXs and RXs.
If you add additional devices in the future, use the Configure Devices tab to configure the IP
addresses.
25. Exit Terra Startup Assistant.
26. To complete additional setup, login to Terra Manager using the default credentials:
user name: service
password: service
Terra Controller Installation and Setup Manual
020-102804-02 Rev. 1 (09-2018)
Copyright
©
2018 Christie Digital Systems USA Inc. All rights reserved.
) and click Assign IPs.
Install and Setup
13