360 YIELD CENTER BANDIT KINZE 3000 Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Landwirtschaftliche Geräte 360 YIELD CENTER BANDIT KINZE 3000 herunter. 360 YIELD CENTER BANDIT KINZE 3000 3 Seiten.

Seite drucken

STEP 3 | ASSEMBLE BANDIT ARM ASSEMBLY

(KIT #540560) & EXTENSION BRACKET

Slide the BANDIT arm assembly over the extension bracket,

ensuring BANDIT arms 8 are facing in the rearward

direction, towards the spring hook 9.

Secure arm assembly to the front holes 1 on the extension

bracket with (2) 3/8" X 1-1/2" bolts and 3/8" flange nuts.

Tighten with 9/16" socket and wrench.

STEP 4 | INSTALL EXTENSION BRACKET

NOTE: Leave nyloc nuts loose on both sides until after the

support strap is installed in STEP 5.

Align holes in extension bracket with the holes on the

row unit. Install flat washer on the 1/2" x 1-1/2" bolt from

hardware kit #540615. Slide bolt through extension

bracket and row unit hole (bolt head on the outside) 1.

Install another washer and hand tighten with nyloc nut

from hardware kit #540615. Do not tighten.

Repeat for other side.

PAGE 2 | 360YIELDCENTER.COM

STEP 5 | INSTALL SUPPORT STRAP

Remove the bolt on the bottom of the depth adjustment

assembly 1 and discard.

Attach the support strap to the back holes 1 on the

extension bracket with (2) 3/8" x 1-1/4" bolts and 3/8"

flange nuts from hardware kit #540615. Tighten bolts with

9/16" socket and wrench.

Secure the top of the support strap to the depth adjustment

assembly using the supplied 3/8" x 1-1/4" bolt 1 and

washer from hardware kit #540615. Ensure all bracketry is

flush when bolt is installed.

NOTE: The extension bracket may need lifted up to align

bolt holes. Tighten the bolt down until there is a flat

connection between the support strap and the depth

adjustment assembly.

Tighten the nyloc nuts that were left loose in STEP 4 with

3/4" socket and wrench securing the BANDIT extension

bracket to the row unit 1.

INSTALLATION INSTRUCTIONS

STEP 6 | INSTALL DISK & HOSE GUIDES

NOTES:

Hose guides are labeled "L" left and "R" right. When

holding them in your hands with the ear tabs facing each

other, your left hand will be holding the left side hose guide

and your right hand will be holding the right side.

The supplied 3/8" x 1" bolt installed in the Bandit pin up

hole is to be used as a "zero" setting and as a stop in case of

spring disengagement.

Insert 5/8" X 3" bolt through the disk. Insert bushing 7

(large side first) and hose guide assembly 8 (ear tab facing out).

Slide assembly into the lower hole on the bandit 9, aligning

the ear tab with corresponding upper hole 1 and secure

with lock nut.

Tighten with 15/16" socket and wrench.

Using a mallet, install provided dust caps over bolt heads.

Route application hose through hole in top of 360 BANDIT

frame 1.

Repeat for other side.

KINZE 3000