360 YIELD CENTER BANDIT KINZE 3000 Installation Instructions - Page 2
Browse online or download pdf Installation Instructions for Farm Equipment 360 YIELD CENTER BANDIT KINZE 3000. 360 YIELD CENTER BANDIT KINZE 3000 3 pages.
8
11
8
10
8
9
STEP 3 | ASSEMBLE BANDIT ARM ASSEMBLY
(KIT #540560) & EXTENSION BRACKET
Slide the BANDIT arm assembly over the extension bracket,
ensuring BANDIT arms 8 are facing in the rearward
direction, towards the spring hook 9.
Secure arm assembly to the front holes 1 on the extension
bracket with (2) 3/8" X 1-1/2" bolts and 3/8" flange nuts.
Tighten with 9/16" socket and wrench.
STEP 4 | INSTALL EXTENSION BRACKET
NOTE: Leave nyloc nuts loose on both sides until after the
support strap is installed in STEP 5.
Align holes in extension bracket with the holes on the
row unit. Install flat washer on the 1/2" x 1-1/2" bolt from
hardware kit #540615. Slide bolt through extension
bracket and row unit hole (bolt head on the outside) 1.
Install another washer and hand tighten with nyloc nut
from hardware kit #540615. Do not tighten.
Repeat for other side.
PAGE 2 | 360YIELDCENTER.COM
8
12
8
14
8
STEP 5 | INSTALL SUPPORT STRAP
Remove the bolt on the bottom of the depth adjustment
assembly 1 and discard.
12
Attach the support strap to the back holes 1 on the
extension bracket with (2) 3/8" x 1-1/4" bolts and 3/8"
10
flange nuts from hardware kit #540615. Tighten bolts with
9/16" socket and wrench.
Secure the top of the support strap to the depth adjustment
assembly using the supplied 3/8" x 1-1/4" bolt 1 and
washer from hardware kit #540615. Ensure all bracketry is
flush when bolt is installed.
NOTE: The extension bracket may need lifted up to align
bolt holes. Tighten the bolt down until there is a flat
connection between the support strap and the depth
adjustment assembly.
11
Tighten the nyloc nuts that were left loose in STEP 4 with
3/4" socket and wrench securing the BANDIT extension
bracket to the row unit 1.
INSTALLATION INSTRUCTIONS
8
13
8
15
13
14
15
20
19
18
17
16
STEP 6 | INSTALL DISK & HOSE GUIDES
NOTES:
Hose guides are labeled "L" left and "R" right. When
holding them in your hands with the ear tabs facing each
other, your left hand will be holding the left side hose guide
and your right hand will be holding the right side.
The supplied 3/8" x 1" bolt installed in the Bandit pin up
hole is to be used as a "zero" setting and as a stop in case of
spring disengagement.
Insert 5/8" X 3" bolt through the disk. Insert bushing 7
(large side first) and hose guide assembly 8 (ear tab facing out).
17
Slide assembly into the lower hole on the bandit 9, aligning
the ear tab with corresponding upper hole 1 and secure
with lock nut.
Tighten with 15/16" socket and wrench.
Using a mallet, install provided dust caps over bolt heads.
Route application hose through hole in top of 360 BANDIT
frame 1.
20
Repeat for other side.
KINZE 3000
16
18
19