Miller ArcStation 60SX Benutzerhandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör für das Schweißen Miller ArcStation 60SX herunter. Miller ArcStation 60SX 16 Seiten.
Seite drucken
B. Table Tops
Four holes must be
together in center of tops.
Tools Needed:
C. Support Rails
1
1
2
1
1
1
1
1
Bottom View
1
Table Tops
Wipe off rust inhibitor from table
tops.
Place table tops flat on the floor.
.
Tops for 60SX model are
shown; solid tops use the same
tapped hole layout.
.
X-pattern top can be on either
side. Check the following
instructions to be sure how
tops will be positioned after
assembly.
Use a mallet to tap tops together so
they touch at the center.
1
Tapped Holes For Front/Rear
Rails
2
Front/Rear Rails
Place four front/rear rails on table
tops as shown, but do not fasten
rails to tops yet.
1
1
2
OM-244997 Page 5