Miller ArcStation 60SX Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria spawalnicze Miller ArcStation 60SX. Miller ArcStation 60SX 16 stron.
![Miller ArcStation 60SX Instrukcja obsługi](/uploads/products/server2/3571843/3571843.jpg)
B. Table Tops
Four holes must be
together in center of tops.
Tools Needed:
C. Support Rails
1
1
2
1
1
1
1
1
Bottom View
1
Table Tops
Wipe off rust inhibitor from table
tops.
Place table tops flat on the floor.
.
Tops for 60SX model are
shown; solid tops use the same
tapped hole layout.
.
X-pattern top can be on either
side. Check the following
instructions to be sure how
tops will be positioned after
assembly.
Use a mallet to tap tops together so
they touch at the center.
1
Tapped Holes For Front/Rear
Rails
2
Front/Rear Rails
Place four front/rear rails on table
tops as shown, but do not fasten
rails to tops yet.
1
1
2
OM-244997 Page 5