Miller VL-M4 Benutzerhandbuch - Seite 22

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör für das Schweißen Miller VL-M4 herunter. Miller VL-M4 36 Seiten. Submerged arc controller for automatic welding

Seite drucken
Miller VL-M4 Benutzerhandbuch

4-10. Terminal Strip TE2 Connection Information

Terminal Number
2
4
77
75
76
32
31
33
A
B
16
17

4-11. Remote 17 Receptacle RC1 Information

REMOTE 17
115 Volts AC
GND
Input Signals For
Ammeter And Voltmeter
Ammeter And Voltmeter
Arc Detect
Arc Detect
Voltage Sensing

4-12. Remote 5 Receptacle RC3 Information

REMOTE 5
Wirefeed Drive
Motor Hookups
OM-189 530 Page 18
Receptacle Location
A on 14-Pin
A normally open set of relay contacts connect terminal 2 to terminal 4 when
START is pressed.
B on 14-Pin
C on 14-Pin
Remote command reference from welding power source.
D on 14-Pin
Remote circuit common.
E on 14-Pin
Output command to welding power source.
G on 14-Pin
Circuit common for 24 and 115 volts ac circuits.
I on 14-Pin
115 volts ac from welding power source (present whenever welding power
source is on).
K on 14-Pin
Chassis ground.
A on 5-Pin
To motor armature (115 volts dc motor).
B on 5-Pin
To motor armature (115 volts dc motor).
C on 5-Pin
To motor field.
D on 5-Pin
To motor field.
User
Socket
Accessible Via
TE1 Terminal #
A
—
B
—
C
—
D
—
E
—
F
—
G
—
H
—
L
40
T
41
P
42
S
43
K
—
M
21
User Accessi-
ble Via TE2
Socket
Terminal #
A
A
B
B
C
16
D
17
E
33
Function Information
Socket Information
115 volts ac output protected by Fuse F2.
Circuit common for 115 volts ac.
Chassis ground.
Input signal from shunt control to positive voltmeter terminal.
Circuit common for ammeter and voltmeter.
Input signal from shunt control to positive ammeter terminal.
A normally open set of contacts in the shunt control close when an
arc is detected and connect G to H to signal the motor board that
an arc was established.
A normally open set of contacts in the shunt control close when an
arc is detected and connect L to T. These points are user accessi-
ble through terminal strip TE1.
+24 volts dc for a flux valve is present on P with respect to S when
an arc is detected. These points are user accessible through termi-
nal strip TE1.
Electrode voltage is picked up through shunt control and input to
this pin.
Volt sense lead from work connection is output on this pin to shunt
control.
Socket Information
To – motor armature (115 volts dc motor).
To + motor armature (115 volts dc motor).
To motor field.
To motor field.
Chassis common.