Miller Subarc DC 1000 Benutzerhandbuch - Seite 28

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Tragbarer Generator Miller Subarc DC 1000 herunter. Miller Subarc DC 1000 48 Seiten.

Seite drucken
Miller Subarc DC 1000 Benutzerhandbuch

3-6. Synchronizing Outputs For Parallel AC Arcs

Y All synchronized units must be set up for ac output ac-
cording to Section 2-9. Do not mix dc and ac output units.
.
Use two-conductor (12 to 20 gauge), with uninsulated ground,
shielded cable to make TE4 connections. Connect ground to
terminal C on TE4.
2
Connections from first to second
welding power source:
terminal A to terminal E,
terminal B to terminal B,
terminal C to terminal C
A
B
C
D
E
TE4 on first
welding power
source
Tools
Needed:
OM-2221 Page 24
Y If there are any questions regarding this procedure,
contact the factory before connecting units.
3/8 in
(10 mm)
Connections from second to third
A
B
C
D
E
TE4 on second
welding power
source
Terminal Strip TE4 Connections For Operating Multiple AC Units In Parallel
1
A
A
B
B
C
C
D
D
E
E
1
3
welding power source:
terminal A to terminal E,
terminal B to terminal B,
terminal C to terminal C
A
B
C
D
E
TE4 on third
welding power
source
Y Turn Off welding power
source and disconnect input
power before opening ac-
cess door.
1
Terminal Strip TE4
This procedure allows the ac out-
puts of two or more units to be syn-
chronized
so
the
match. To synchronize outputs,
make connections between termi-
nal strip TE4 on each ac output unit
as shown in illustration.
.
Do not disturb factory connec-
tions to terminal strip TE4.
Y Ensure that primary input
power conductors are con-
nected to each unit in the
same sequence (L1 to L1, L2
to L2, and L3 to L3). See Sec-
tion 2-15 for information on
connecting input power. See
Section 2-16 for information
on testing for proper primary
phase sequence.
Y Always test for correct phas-
ing before paralleling ac out-
puts according to Section
3-9.
2
Lead Being Connected To
TE4
3
Securing Screw
Strip 3/8 in (10 mm) insulation off
end of lead, insert end into proper
location on TE4, and tighten appli-
cable securing screw.
Close and secure access door.
.
Make certain control board
PC1 is set for synchronized
parallel ac arcs (see Section
3-8).
Connections from third to fourth
welding power source:
terminal A to terminal E,
terminal B to terminal B,
terminal C to terminal C
Y When using multiple arcs in
parallel, be sure to follow
unit setup instructions care-
fully. Severe damage to units
may occur if units are not
correctly connected for par-
allel operation.
Repeat same connection se-
quence on following
welding power sources
waveforms
ST-801 882-A