Aquapeutics Caribbean Installationshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationshandbuch für Duschkabinen Aquapeutics Caribbean herunter. Aquapeutics Caribbean 17 Seiten.

3. Installation Steps

Place the shower floor unit (as pictured below 1a)

16-24 inches from its final installed location. Now adjust

the leveling feet (1c) to bring the unit flat and level by

using a 3 foot level (1b) and an open end or adjustable

wrench to turn the adjusting nuts. This will raise or lower

each corner as needed. Once the unit is level and flat lock

each leg into position with its locking nut

Figure1

2. The fixed glass wall (minus the sliding glass

door) must be assembled first before it is installed

to the tub. Take care when inserting the glass

components into the aluminum channels. The

Fixed glass component installation diagram (Figure

2) is below. Please insert the rubber gaskets

between the glass and aluminum channels where

indicated.

Figure2

The glass walls are framed by the curved rails on

the top and bottom and with the aluminum

extrusions to the left and right.

① Connect the left and right fixed glass walls (2c)

to the upper and lower aluminum curved rails

(2d) by using 8 pieces 3/16 x 1 ¼ inch (2a)

screws with the plastic chrome spacer in

between the curved rails and the vertical side

channel. As shown in figure 2.1

②Use 4 pieces 3/16X ¾" screws (2e) to connect

the roller track cover (2f) with the upper and

lower inside rails. (Figure2.2)

③ According to the arrow tips direction, insert the

left and right side corner aluminum extrutions

(2g) into the fixed glasses to complete the

curved fixed glass wall (Figure 3).

Chrome spacer

Figure2.1

Figure 2.2

Figure 3