Aquapeutics Caribbean 설치 매뉴얼 - 페이지 6

{카테고리_이름} Aquapeutics Caribbean에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquapeutics Caribbean 17 페이지.

3. Installation Steps

1.
Place the shower floor unit (as pictured below 1a)
16-24 inches from its final installed location. Now adjust
the leveling feet (1c) to bring the unit flat and level by
using a 3 foot level (1b) and an open end or adjustable
wrench to turn the adjusting nuts. This will raise or lower
each corner as needed. Once the unit is level and flat lock
each leg into position with its locking nut
1a
Figure1
2. The fixed glass wall (minus the sliding glass
door) must be assembled first before it is installed
to the tub. Take care when inserting the glass
components into the aluminum channels. The
Fixed glass component installation diagram (Figure
2) is below. Please insert the rubber gaskets
between the glass and aluminum channels where
indicated.
2g
2b
2f
2c
Figure2
2f
The glass walls are framed by the curved rails on
the top and bottom and with the aluminum
extrusions to the left and right.
.
1b
1c
2a
2b
2d
2e
2c
2d
① Connect the left and right fixed glass walls (2c)
to the upper and lower aluminum curved rails
(2d) by using 8 pieces 3/16 x 1 ¼ inch (2a)
screws with the plastic chrome spacer in
between the curved rails and the vertical side
channel. As shown in figure 2.1
②Use 4 pieces 3/16X ¾" screws (2e) to connect
the roller track cover (2f) with the upper and
lower inside rails. (Figure2.2)
2g
③ According to the arrow tips direction, insert the
left and right side corner aluminum extrutions
(2g) into the fixed glasses to complete the
curved fixed glass wall (Figure 3).
5
Chrome spacer
Figure2.1
Figure 2.2
2h
Figure 3