AQUAPHOR RO-202S Betriebshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Water Filtration Systems AQUAPHOR RO-202S herunter. AQUAPHOR RO-202S 16 Seiten. Reverse osmosis system

Seite drucken

6. Launching RO-202S

Step 1. Connecting inlet tubes

• Connect the inlet tubes according to the

diagram shown in Fig. 9.

Step 2. Preparing your RO-202S for use

• Remove the overwrapping film from the

cartridges.

• Remove transport plugs (if any) from the

cartridges.

• Rinse the O-rings of the cartridge under a

water stream.

• The cartridges are inserted into the corres-

ponding collectors until they stop and turned

clockwise, as shown in Fig. 10a, until a click.

• To remove a cartridge, press the lock button

as far as it will go and hold it while turning the

cartridge counter clockwise, as shown in Fig.

10b, and remove it.

• Install the cartridges as shown in Fig. 11.

• Insert the plug of the power supply into the

outlet, and the plug from the power supply

into the socket in your RO-202S unit (Fig. 12).

Step 3. Flushing the pre-treatment unit

• Open the treated water tap.

• Turn the inlet cock of the connecting assembly

to its open position. The cartridge life indicator

lights blink (the light signal is be followed by

an audible one).

• On the front panel of your RO-202S (Fig. 13),

flash the PUSH button 3 times to start the

flushing mode. At this, 5 audible signals sound,

the cartridge life indicator lights go out and the

flushing mode of the pre-treatment unit starts

and lasts 30 minutes.

• First, air comes out of the system with some

noise.

• Make sure the RO-202S connections are tight.

Fig. 12

From the

connecting

assembly

Fig. 9

Fig. 10a

Service plug (supplied)

К2

Fig.11

To the drain

clamp

To the treated

water tap

Fig. 10b

K7BM