BURL BMB4 Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Medienkonverter BURL BMB4 herunter. BURL BMB4 14 Seiten.

1. GETTING STARTED

1.1 Register

Please register all serial numbers for your B80 MOTHERSHIP chassis, all Daughter Cards,

and BP-300 power supply.

You must register to activate your warranty! Please visit: www.burlaudio.com/register.

1.2 Check Jumper Settings On BMB4

The B80 MOTHERSHIP is fully modular, accommodating a wide variety of I/O needs. Jumper

settings on the BMB4 Motherboard allow for different I/O routing possibilities.

Find H9 on the BMB4 Motherboard, as shown in Image 1 below.

Use Examples A through D (on pages 2 and 3) to determine which setting to use based

on your configuration.

See Channel Mapping for Jumper Settings charts on page 4.

Jumper positions 1 and 2 determine the INPUT channel mapping, this allows you to set

the configuration for each card slot in the MOTHERSHIP.

(Configurations possible: 4 Ch. per slot / 8 Ch. per slot / 8 and 4 Ch. per slot)

Jumper positions 3 and 4 determine the OUTPUT channel mapping, this allows you to

change where the OUTPUTS start in the MOTHERSHIP chassis.

(Output can start in slots 3, 5 & 7)

Jumpers on both 1 and 2 are for B16 MOTHERSHIP. Do not use with B80 chassis.

Image 1: Locate the H9 Header on BMB4 Motherboard. From the rear of

the chassis, BMB4 is on the far left. The H9 Header is highlighted. In this

example, jumpers are on 1 and 3.

SECTION 1