BURL BMB4 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} BURL BMB4에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BURL BMB4 14 페이지.
페이지 인쇄1. GETTING STARTED
1.1 Register
Please register all serial numbers for your B80 MOTHERSHIP chassis, all Daughter Cards,
and BP-300 power supply.
You must register to activate your warranty! Please visit: www.burlaudio.com/register.
1.2 Check Jumper Settings On BMB4
The B80 MOTHERSHIP is fully modular, accommodating a wide variety of I/O needs. Jumper
settings on the BMB4 Motherboard allow for different I/O routing possibilities.
1.
Find H9 on the BMB4 Motherboard, as shown in Image 1 below.
2.
Use Examples A through D (on pages 2 and 3) to determine which setting to use based
on your configuration.
3.
See Channel Mapping for Jumper Settings charts on page 4.
4.
Jumper positions 1 and 2 determine the INPUT channel mapping, this allows you to set
the configuration for each card slot in the MOTHERSHIP.
(Configurations possible: 4 Ch. per slot / 8 Ch. per slot / 8 and 4 Ch. per slot)
5.
Jumper positions 3 and 4 determine the OUTPUT channel mapping, this allows you to
change where the OUTPUTS start in the MOTHERSHIP chassis.
(Output can start in slots 3, 5 & 7)
6.
Jumpers on both 1 and 2 are for B16 MOTHERSHIP. Do not use with B80 chassis.
Image 1: Locate the H9 Header on BMB4 Motherboard. From the rear of
the chassis, BMB4 is on the far left. The H9 Header is highlighted. In this
example, jumpers are on 1 and 3.
SECTION 1
1