Diamond TQ-1800 Installations- und Betriebshandbuch - Seite 17

Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Kommerzielle Lebensmittelausrüstung Diamond TQ-1800 herunter. Diamond TQ-1800 20 Seiten. Electric conveyor toasters

MAINTENANCE

GENERAL

The Hatco Toast-Qwik
®
are
designed
for
performance, with minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any maintenance.
WARNING
If the Warning light on the control panel is lit,
appliance is malfunctioning. Turn OFF the power
to the unit and allow to cool. Once cool,
disconnect appliance from power supply and
have unit serviced by a qualified technician.

CLEANING

Exterior
To preserve the bright finish of the unit, it is
recommended that the exterior surfaces be wiped
daily with a damp cloth. Stubborn stains may be
removed with a good stainless steel cleaner or a
non-abrasive cleaner. Hard to reach areas should
be cleaned with a small brush and mild soap.
CAUTION
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your Toast-
Qwik toaster marring its appearance and making
it susceptible to soil accumulation.
Toast Crumb Tray & Toast Collector Pan
Remove from unit and wash with soap and water,
then rinse.
Toast Feed Ramp
Press in the two wire spokes and remove ramp from
unit. Wipe clean with a soft, damp cloth or soak the
ramp in a mild solution of 1 cup ammonia and
1 gallon of water (227 milliliters and 3.785 liters).
Re-install ramp by aligning wire spokes with holes in
toaster.
Bottom Heating Reflector
The bottom heating element reflector has slots
which allow bread crumbs to drop through to the
crumb tray. Over an extended period of use bread
crumbs may buildup on the reflector and not drop
through onto the tray. To remove buildup, allow the
toaster to cool and wipe the crumbs onto the crumb
tray using a bristle brush.
Form No. TQ2M-1005
Electric Conveyor Toasters
maximum
durability

LUBRICATION

The conveyor gear motor and conveyor system are
and
permanently lubricated and require no lubrication.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
This product has no "user" serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
14
WARNING
WARNING
WARNING
parts
do
not
have
the