3branch KURVE Montageanleitung Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Inneneinrichtung 3branch KURVE herunter. 3branch KURVE 6 Seiten. Desk w/hand crank adjustable height "t" base
Seite drucken
STEP 17:
THREAD & TIGHTEN CASTER STEMS INTO INSERTS LOCATED
IN THE BOTTOM OF THE BASE ASEEMBLY.
NOTE: BASE IS ALSO AVAILABLE WITH OPTIONAL LEVELERS.
STEP 19:
INSTALL GROMMETS IN HOLES BORED THRU TOP PANEL &
APRON/SUB-TOP ASSEMBL NEAR EACH END.
NOTE: SOLID SURFACE TOP WOULD BE ATTACHED TO APRON/
SUB-TOP ASSEMBLY WITH SILICONE ADHESIVE @ THIS STEP
IF APPLICABLE.
STEP 20:
MOUNT MAGNETIC WIRE CHANNEL TO DESIRED BASE COLUMN.
KURVE COLLECTION
3branch
product design solutions
CASTERS
STEP 18:
TURN ASSEMBLED DESK UPRIGHT.
*CAUTION: TWO PEOPLE REQ'D TO TURN TABLE OVER TO AVOID
DAMAGE TO DESK PARTS & PERSONAL INJURY!
*CAUTION: DO NOT PIVOT ON TABLE BASE TO AVOID DAMAGE
TO BASE!
GROMMETS
MAGNETIC
WIRE CHANNEL
STEP 21:
ROLL ASSEMBLED DESK IN PLACE.
STEP 22:
PULL HANDLE OUT TO RAISE & LOWER TOP TO DESIRED HEIGHT.
TURN HANDLE CLOCKWISE TO RAISE TABLE.
TURN HANDLE COUNTER CLOCKWISE TO LOWER TABLE.
PUSH HANDLE IN TO STORE BELOW TOP.
DESCRIPTION:
P 847.291.3900
F 847.291.3901
www.3branch.com
DATE:
09.23.21
KURVE DESK W/HAND CRANK ADJUSTABLE
HEIGHT "T" BASE
ASSEMBLY INSTRUCTIONS
DWG #
SK-KU-DESK-ADJT-ASSEMBLY-01
REV #
0
SHEET
6 OF 6