HP StorageWorks 7110 - Virtual Array Upgrade-Anweisungen - Seite 10

Blättern Sie online oder laden Sie pdf Upgrade-Anweisungen für Schalter HP StorageWorks 7110 - Virtual Array herunter. HP StorageWorks 7110 - Virtual Array 12 Seiten. Private loop (hubs/direct connect)
Auch für HP StorageWorks 7110 - Virtual Array: Handbuch verwenden (34 seiten), Anweisungen (4 seiten), Handbuch (4 seiten), Handbuch (4 seiten), Einbauanleitung (2 seiten), Handbuch (2 seiten), Handbuch (1 seiten), Handbuch (1 seiten)

Seite drucken

HP StorageWorks 7110 - Virtual Array Upgrade-Anweisungen

Restore Array Data

Upgrading a VA 7100/7400 to a VA 7410/7110

Step 12. Format the array controller enclosure

Skip this step because the array has already been formatted.

Step 19. Build the Host Port Behavior Table

The host port behavior table is stored on the array mid-plane and it should not

be necessary to recreate the table. However, it is recommended that you read

the table from the array and check it to make sure it contains the proper

entries. Use the following command to read the table to the file identified by

filename

armhost -r -f filename array-id

Step 21. Build the Secure Manager LUN Security Table

If the Secure Manager LUN security table was saved from the original array,

use the configuration information to restore the LUN security table. Use the

following command to write the LUN security table to the array from the file

saved earlier:

armsecure -w -f armsecure_<array_id>.txt -p password

<array_id>

After the LUN configuration has been restored, the data can be restored from

the backup medium.