HP StorageWorks 7110 - Virtual Array 업그레이드 지침 - 페이지 10

{카테고리_이름} HP StorageWorks 7110 - Virtual Array에 대한 업그레이드 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks 7110 - Virtual Array 12 페이지. Private loop (hubs/direct connect)
HP StorageWorks 7110 - Virtual Array에 대해서도 마찬가지입니다: 매뉴얼 사용 (34 페이지), 지침 (4 페이지), 매뉴얼 (4 페이지), 매뉴얼 (4 페이지), 설치 지침 (2 페이지), 매뉴얼 (2 페이지), 매뉴얼 (1 페이지), 매뉴얼 (1 페이지)

페이지 인쇄

HP StorageWorks 7110 - Virtual Array 업그레이드 지침

Restore Array Data

Upgrading a VA 7100/7400 to a VA 7410/7110

Step 12. Format the array controller enclosure

Skip this step because the array has already been formatted.

Step 19. Build the Host Port Behavior Table

The host port behavior table is stored on the array mid-plane and it should not

be necessary to recreate the table. However, it is recommended that you read

the table from the array and check it to make sure it contains the proper

entries. Use the following command to read the table to the file identified by

filename

armhost -r -f filename array-id

Step 21. Build the Secure Manager LUN Security Table

If the Secure Manager LUN security table was saved from the original array,

use the configuration information to restore the LUN security table. Use the

following command to write the LUN security table to the array from the file

saved earlier:

armsecure -w -f armsecure_<array_id>.txt -p password

<array_id>

After the LUN configuration has been restored, the data can be restored from

the backup medium.