Diamond Tech DIAMOND MAX ELITE Betriebshandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Schleifer Diamond Tech DIAMOND MAX ELITE herunter. Diamond Tech DIAMOND MAX ELITE 6 Seiten. Two-in-one glass grinder

Seite drucken

DIAMOND MAX

ELITE INSTRUCTION MANUAL - PAGE 4

™

Deluxe Model Only

The Diamond Max Deluxe comes with 3/4" and 1/4" Silver Bullet

grinding versatility.

1. To install the 3/4" grinder bit, remove 1" grinder bit.

2. Snap spacing collar into the grid surface to reduce the size of the

opening (FIG.10).

3. Slide the bit onto the motor shaft, positioning the set screw over the flat

side of the motor shaft. Position the bit on the shaft so at least 1/8" of the

bit surface is exposed above the grid work surface.

4. Secure the bit to the shaft by turning the set screw clockwise with the

hex wrench.

5. The 1/4" grinder bit is useful for both drilling holes and intricate grinding.

The 1/4" bit is placed directly onto the top of the shaft and tightened with

the hex screw. It can also be installed without removing the 1" or 3/4" bit by

lowering the position of these bits on the shaft and installing the 1/4" bit on

top of the existing bit. You now have two bits to work simultaneously

6. Deluxe models also come with an Easy-On

you to easily turn the grinder on or off with a simple tap of the toe. To use,

plug grinder directly into the foot-switch, then plug foot-switch into any

outlet. Turn grinder to the ON position.

Grinder Use and Maintenance

A. Bit Use

Remember to wear safety glasses or install a protective face shield

when grinding.

1. If you are a first time user, get the feel of the grinder by turning on the

grinder and grinding a piece of scrap glass. Begin by pushing the glass

into the grinding bit using light pressure and moving the glass back and

forth across the bit (FIG.11).

2. Slowly increase the pressure until you feel comfortable with the grinding

speed and your control. You'll quickly learn the optimum grinding pressure

for the types of glass you use.

3. Stop periodically and check the sponge placement and water level.

Grinding without water greatly reduces the life of your grinding bits.

4. Over time, a bit may grind less effectively causing your glass to chip this is

a result of wearing away of the bit's diamond surface. When this happens,

it is time to expose a new portion of the diamond surface. Loosen the set

screw using the hex wrench and move the grinding bit up on the shaft to

expose a new 1/8" section of diamond.

5. Secure the bit back in place making sure to tighten it against the flat side of

the motor shaft. Reposition the sponge if needed.

B. Disk Use

1. When ready to start disk grinding, remove the grid work surface, fill the

water reservoir 3/4 full, open the slide valve (FIG.12) and replace the

surface grid. If needed, you can increase water supply to the grinding disk

by slightly enlarging the holes located behind the slide valve using a paper

clip or a ridged metal object. Use caution to prevent over-enlargement of

the holes. Your Diamond Max

base to prevent excess water from building up under the disk (FIG.13).

foot-switch. This switch allows

™

comes with a drain opening on the grinder

™

Bits for

™

Slide Valve Closed

Slide Valve Open

FIG.7

FIG.8

FIG.9

FIG.10

FIG.11

FIG.12