Diamond Tech International FIREWORKS Beginners Beadmaking Kit Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Zubehör Diamond Tech International FIREWORKS Beginners Beadmaking Kit herunter. Diamond Tech International FIREWORKS Beginners Beadmaking Kit 4 Seiten.

Seite drucken

Please read and follow instructions completely before beginning. When working with

glass, protect your feet and legs by wearing pants and closed top shoes. Eye protection

is essential. Cold glass, when heated too quickly, may fragment off. Always wear eye

protective gear to shield yourself from possible hazardous glass projectiles. Use caution

while working with hot torch and glass to ensure proper and safe use. Otherwise, severe

burns can occur. Work area should be free from curtains or other combustible materials.

Make sure work area is also well ventilated. Keep a fire extiguisher handy in your work

area for emergency purposes.

1. Fiber Blanket-Used to slowly cool completed bead.

2. Bottle Holder-Fireworks bottle holder assembly clamps on the edge of any table

to hold the MAPP Gas tank securely in place without slipping.

3. Bead Release-A thick liquid coating that prevents glass from sticking to metal.

4. Fireworks Torch

Designed

exclusively for

Fireworks, this

unique torch head

has a self- igniting

system for easy use.

CAUTION: Do not

store with torch attached to fuel tank.

5. Rake-Use rake to manipulate molten

glass by dragging, raking, feathering or swirling the surface. It can be used to

make air bubbles inside the bead or poke holes through the glass. Fireworks

rake has a bent tip for a comfort grip.

6. Mandrels-Stainless steel rods used to wrap molten glass around to create a

bead. They have a low heat transfer, keeping your fingers cool while working in

direct open flame.

7. Glass Rods-Your kit contains an assortment of translucent and opaque Italian

glass rods. They are 104 COE and heat evenly and quickly in the torch flame.

8. Scrubber-Helps to remove bead and mandrel release residue.

9. Marver - Roll or press your glass into the ridges of this 2" x 4" textured surface

to make interesting patterns. Experiment by rolling bead at different angles.

Warm marver before using by holding 6" from flame for approximately 15

seconds.

Safety Instructions

Kit Contents