Diamond Tech International FIREWORKS Beginners Beadmaking Kit 사용 설명서 - 페이지 2
{카테고리_이름} Diamond Tech International FIREWORKS Beginners Beadmaking Kit에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Tech International FIREWORKS Beginners Beadmaking Kit 4 페이지.
페이지 인쇄Please read and follow instructions completely before beginning. When working with
glass, protect your feet and legs by wearing pants and closed top shoes. Eye protection
is essential. Cold glass, when heated too quickly, may fragment off. Always wear eye
protective gear to shield yourself from possible hazardous glass projectiles. Use caution
while working with hot torch and glass to ensure proper and safe use. Otherwise, severe
burns can occur. Work area should be free from curtains or other combustible materials.
Make sure work area is also well ventilated. Keep a fire extiguisher handy in your work
area for emergency purposes.
1. Fiber Blanket-Used to slowly cool completed bead.
2. Bottle Holder-Fireworks bottle holder assembly clamps on the edge of any table
to hold the MAPP Gas tank securely in place without slipping.
3. Bead Release-A thick liquid coating that prevents glass from sticking to metal.
4. Fireworks Torch
Designed
exclusively for
Fireworks, this
unique torch head
has a self- igniting
system for easy use.
CAUTION: Do not
store with torch attached to fuel tank.
5. Rake-Use rake to manipulate molten
glass by dragging, raking, feathering or swirling the surface. It can be used to
make air bubbles inside the bead or poke holes through the glass. Fireworks
rake has a bent tip for a comfort grip.
6. Mandrels-Stainless steel rods used to wrap molten glass around to create a
bead. They have a low heat transfer, keeping your fingers cool while working in
direct open flame.
7. Glass Rods-Your kit contains an assortment of translucent and opaque Italian
glass rods. They are 104 COE and heat evenly and quickly in the torch flame.
8. Scrubber-Helps to remove bead and mandrel release residue.
9. Marver - Roll or press your glass into the ridges of this 2" x 4" textured surface
to make interesting patterns. Experiment by rolling bead at different angles.
Warm marver before using by holding 6" from flame for approximately 15
seconds.
Safety Instructions
Kit Contents
4
9
10
3
8
7
5
1
2
6