Panasonic RQTV0080-1P Betriebsanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Panasonic RQTV0080-1P herunter. Panasonic RQTV0080-1P 24 Seiten. Panasonic cd stereo system operating instructions model no. sc-pm23 rqtv0080-1p

Seite drucken

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the
remedies indicated in the chart do not solve the problem, refer to the "Customer Services Directory" on page 16 if
you reside in the U.S.A., or refer to the "Product information" on page 17 if you reside in Canada.
Common problems
No sound.
Sound is unfi xed, reversed or comes
from one speaker only.
Humming heard during play.
"ERROR" is displayed.
"– –:– –" appears on the display.
"F76" is displayed.
Listening to the radio
Noise is heard.
The stereo indicator fl ickers or doesn't
light.
Sound is distorted.
A beat sound is heard.
A low hum is heard during AM
broadcast.
When there is a television set nearby
The picture on the TV
disappears or stripes appear
on the screen.
Using the cassette deck
Recording is not possible.
Playing discs
The display is wrong or play
won't start.
The remote control
Remote control doesn't work.
14
Turn the volume up.
The speaker cords may not be connected properly. Turn the unit off, check and correct the
connections and turn the unit on (refer to page 4).
Check the speaker connections (refer to page 4).
An AC power supply cord or fl uorescent light is near the cables. Keep other appliances and
cords away from this unit's cables.
Incorrect operation performed. Read the instructions and try again.
You plugged the AC power supply cord in for the fi rst time or there was a power failure
recently.
Set the time (refer to page 11).
Check and correct the speaker cord connections (refer to page 4).
If this does not fi x the problem, there is a power supply problem. Consult the dealer.
Use an outdoor antenna (refer to page 4).
Turn the TV off or separate it from the unit.
Separate the antenna from other cables and cords.
The location and direction of the antenna are incorrect. If you are using an indoor antenna,
change to an outdoor antenna (refer to page 4).
The TV antenna wire is too close to the unit. Separate the antenna wire of the TV set from
the unit.
If the erasure prevention tabs have been removed, cover the holes with adhesive tape (refer
to page 9).
The disc may be upside down (refer to page 7).
Wipe the disc.
Replace the disc if it is scratched, warped, or non-standard.
Condensation may have formed inside the unit due to a sudden change in temperature. Wait
about an hour for it to clear and try again.
Check that the batteries are inserted correctly (refer to page 5).
Replace the batteries if they are worn.