Panasonic RX-DT610 Betriebsanleitung - Seite 17

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo System Panasonic RX-DT610 herunter. Panasonic RX-DT610 46 Seiten. Portable stereo component system

Seite drucken

RADIO

@ Manual tuning

Use tuning buttons to tune the radio to the desired broadcast

frequency. The frequency changes up or down, each time

the "+" or "—" button is pressed, respectively. The incre-

ment of each step is determined by the band selected.

1. Press the operation switch to turn on the unit.

2. Press "TUNER/BAND"

button of the function select

buttons.

3. Press the "TUNER/BAND"

button again to select the

desired radio band (FM1, FM2, LW or MW).

The corresponding band indicator will appear.

4. Tune in the radio station using the tuning buttons.

Press the "+" or "—" button for each step required until

the desired frequency appears on the display.

When

tuning the station,

the frequency

display will

change as follows:

FM:

50kHz step

LW:

9kHz step

MW:

9kHz step

For FM reception, press the FM mode/beat proof button

to select the stereo mode. The stereo ("ST") indicator

will appear on the display when the FM stereo broadcast

is being received.

If FM stereo reception is poor (excessive noise, stereo

indicator flickers), press the FM mode/beat proof button

to indicate "MONO" on the display. This will reduce the

noise and provide clear reception; however, the broad-

cast will not be heard in stereo.

Tuning indicator

Stereo indicator

TUNED

Monaural indicator

5. Adjust volume and balance.

@ FM auto tuning

In the FM mode, the FM auto tuning feature is activated by

pressing

the desired

tuning button

until the frequency

changes continuously. Upon releasing the button, the next

station on the "dial" is automatically tuned in.

1. Follow the same procedures as described in steps 1-3 of

"Manual tuning".

2. Press the "+"

or "—

1 second.

The frequency display will change and when a broadcast

is received, it will stop automatically.

While tuning (the display is changing), the muting oper-

ates and the sounds cannot be heard.

If the correct reception cannot be done by the FM auto

tuning, the manual tuning is recommended.

tuning button

for more

than

ENGL