Dictator E8 Technisches Handbuch - Seite 15

Blättern Sie online oder laden Sie pdf Technisches Handbuch für Kontrollsysteme Dictator E8 herunter. Dictator E8 19 Seiten.

Seite drucken

IV/1 Codes in the Display

of the E8

Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail [email protected] • 20200703

IV. Diagnostics/Indication of Errors

In the display of the control system certain combinations of letters and

numbers are shown to indicate the status of the control system. This

facilitates adjustments and helps to locate errors.

Error

Meaning

Code

RES

Press the RESET button on

the casing.

ALA

Alarm

Short circuit in the power

supply of the motor

SCE

Short circuit in the power

supply of the magnet

S-1

STOP 1 active

S-2

STOP 2 active

S-3

STOP 3 active

T01

Error due to too long

operating time

Continuation on the next page

Technical Manual E8

Possible Causes /

Measures

In general a RESET is required to restart

the control system after switching on the

current or after an alarm.

PLEASE NOTE: As long as the alarm is

still active (check smoke detector or

release button), the RESET will not work.

In case the gate has not been closed

completely after an alarm: Turn off the

current and switch it on again, wait till

the gate has closed completely and then

press RESET.

One or several smoke detectors have

set off.

In case the light barrier is connected

here: please check if anything is in its

survey area.

Please check which maximum operating

time has been adjusted (adjustable bet-

ween 3 and 30 minutes, parameter P-

E). Normally this error occurs whenever

the current supply of the gate operator

is interrupted or the movement of the

gate is obstructed.

Press RESET button (after the current

supply has been restored). Now the

control system is ready to work again.

Page 05.023.15