Axis 290A Installationshandbuch

Blättern Sie online oder laden Sie pdf Installationshandbuch für Kamera-Zubehör Axis 290A herunter. Axis 290A 4 Seiten. Outdoor housing
Auch für Axis 290A: Installationsanleitung Handbuch (8 seiten)

Seite drucken

290A Installation Guide

1. Unpacking

In your box with the 290A housing you will find a small plas-

tic bag containing:

2. Fitting your camera inside the housing

Recommendation: Fit the camera in indoor conditions.

2.1. Open the housing by releasing the two clips on the side.

2.2. Undo the two screws (6) on the camera mounting board

(7) and keep them safe (see Picture 1). Slide the board

backwards and lift it out.

Picture 1

2.3. Attach the lens to the camera (refer to the Axis Installa-

tion Guide provided with the Axis camera).

290A Outdoor Housing

No.

1. One large allen key

2. One small allen key

3. Two locking screws

4. Four M8 wall fixings

5. Four plugs (11x50

mm) for use in solid

walls

2.4. Attach the camera to the camera mounting board (7)

using the screw attached to the board. You will find a

screw hole (8) at the bottom of the camera (see Picture

2). Before tightening the screw, position the camera

with the board inside the housing (with the lens to the

front) (see Picture 1) and determine the camera's cor-

rect position.

Recommendation: The lens should be as close to the

window as possible.

Caution: Allow sufficient space between the lens and

window to accommodate the lens' zoom function. Once

the correct position has been established, lift out the

camera with the board while keeping it in the correct

position. Tighten the screw at the bottom to securely

affix the camera to the board.

Caution: The heater at the front of the housing unit be-

comes hot when in operation. Position the cable con-

nected from the DC IRIS socket to the lens so that it does

not touch the heater.

Caution: Do not over-tighten the screw as you may

damage the camera.

2.5. Position the camera with the board inside the housing

as before (see Picture 1). Make sure the board is inserted

under the lugs beneath the window in its most forward

position. Use the two screws (6) undone under 2.2 to

mount the board with the camera and lens back into the

housing.

2.6.Close the housing with the two clips on the side.

Your housing is now ready for installation outdoors.

290A

Picture 2

1/4