Axis 290A Installationshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationshandbuch für Kamera-Zubehör Axis 290A herunter. Axis 290A 4 Seiten. Outdoor housing
Auch für Axis 290A: Installationsanleitung Handbuch (8 seiten)

Seite drucken

290A Installation Guide

cable going through the smaller hole. Attach the hous-

ing to the swivel by tightening up the four screws held

in the swivel. Use the small allen key (2) to do this.

4. Connecting your camera

Warning: Only work inside the housing in dry weather con-

ditions. Rain water or excessive moisture kept inside the

housing may cause serious damage to the camera, other sys-

tem equipment or even fire. It also could seriously endanger

the health and safety of humans or animals. Water or mois-

ture kept inside the housing may also cause prolonged con-

densation on the window disturbing the picture quality when

in operation.

Warning: Apparatus works on 100-240VAC. Danger of elec-

trical shock. Ensure that mains is disconnected before con-

tinuing the installation.

4.1. Open the housing by releasing the two clips on the side.

4.2. Strip back the mains power cable by 50mm. The mini-

mum conductor area for installation of the housing is

0.5mm

Warning: Regulations relating to other parts of the sys-

tem installation may require a bigger conductor area.

You are responsible that the requirements of these reg-

ulations are met.

4.3. Route the power cable through the cable tie (15). Wire

into the fused terminal block (16) as follows: Blue = neu-

tral (N), Brown = live (L), Green/yellow = earth. Refer to

Picture 6 for a full wiring diagram for the apparatus.

Picture 5

Picture 6 - Wiring diagram 290A

4.4 Caution: Ensure that wires are correctly and securely

wired into the terminal block (16). No bare wire should

be showing.

After this cautionary check, tighten the cable tie (15) so

that the power cable is held firmly.

4.5. Attach your RJ45 connector (not supplied) to the CAT.5

cable allowing sufficient cable to reach the back of the

camera. Once you have fitted the connector plug it into

the network connector at the back of your camera (see

Picture 7). If you are installing an AXIS 2420 camera

and are using Coaxial cable instead of CAT.5 refer to

chapter 7 of this manual.

Picture 8

Power socket on 2110/2120

4.6. When installing an AXIS 2110/2120 camera plug the

green power connector coming from the 12VDC power

supply into the socket labelled I/O (see Picture 8). When

installing an AXIS 2420 camera plug the green power

connector into the socket labelled I/O-A.

5A, 250V

Fuse

Warning: Do not plug the green connector into the

socket labelled I/0-B. This will damage the camera. For

further details on how to connect your camera refer to

the Axis Installation Guide provided with the camera.

5. Completing your installation

5.1. Before closing the housing, check the following:

• Ensure that all cables and connections are correctly

and safely installed.

Caution: The heater at the front of the housing unit be-

comes hot when in operation. Position the cable con-

nected from the DC IRIS socket to the lens so that it does

not touch the heater.

• Ensure that the lens setting is correct and make final

adjustments if required (refer to Axis Install Guide).

3/4

Picture 7

Picture 9

Power socket on 2420