Olympus BH2 Series Zerlegung, Reinigung und Wiederzusammenbau - Seite 13

Blättern Sie online oder laden Sie pdf Zerlegung, Reinigung und Wiederzusammenbau für Mikroskop Olympus BH2 Series herunter. Olympus BH2 Series 45 Seiten. Phase contrast
Auch für Olympus BH2 Series: Handbuch zur Fehlersuche und -anpassung (46 seiten), Vollständige Demontage, Reinigung und Wiedermontage (23 seiten), Vollständige Demontage, Reinigung und Wiedermontage (40 seiten), Handbuch (6 seiten), Installationshandbuch (9 seiten)

Reassemble the Locking Thumbscrew (BHS/BHT)

Insert the extension spring into the bore of the

stationary inner barrel of the locking thumbscrew (see

Figure

22).

Figure 22 – Insert spring into the bore of the inner barrel

Apply a light coating of a suitable grease (item 1 of

Appendix

1) to the shaft of the plunger rod (see

22). Do not grease the larger-diameter plunger end.

Figure 23 – Lightly grease the shaft of the plunger rod

Insert the freshly greased plunger rod into the bore of

the stationary inner barrel of the locking thumbscrew

(see

Figure

24).

Figure 24 – Insert plunger into bore of the inner barrel

Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames

Apply a light coating of a suitable grease (item 1 of

Appendix

inner barrel of the locking thumbscrew (see

Figure 25 – Apply grease to threads of the inner barrel

Reinstall the knurled outer barrel onto the freshly

greased stationary inner barrel of the locking

thumbscrew and snug it down until the smooth end of

Figure

the knurled outer barrel contacts the stationary inner

barrel (see

Figure 26 – Reinstall the knurled outer barrel

Test the freedom of motion of the plunger by

depressing the plunger with your finger, then releasing

it and allowing it to return to the fully extended position

(see

Figure

signs of binding, excess friction, or sluggishness.

Figure 27 – Test the motion of the spring-loaded plunger

1) to the exposed threads of the stationary

Figure

26).

27). The plunger should move without any

Revision 1

Figure

25).

Page 13 of 45