Olympus SZ2-STU1 Anleitung Handbuch - Seite 10

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Laborausrüstung Olympus SZ2-STU1 herunter. Olympus SZ2-STU1 20 Seiten. Universal stand, table clamp stand

Seite drucken

IMPORTANT

SAFETY PRECAUTIONS

Top view

SZ2-STU2

Fig. 12

Fig. 13

1. Install the stand on a level desktop (inclination less than 3°).

2. When moving the stand, make sure that the clamping mechanisms are

secured tightly and lift the stand by holding it by the base plate. If the

stand is held by the horizontal arm or column alone, the base plate may

drop.

3. The load of the stand is limited, and its stability is variable depending on

the orientation of the horizontal arm. (Fig. 12)

· When the horizontal arm is extended at maximum, the load to the arm

of the SZX stand arm is limited as shown in the following table.*

Front 90°

Max. 10 kg

(Max. 8.8 kg)

Left side 105°

Max. 6 kg

(Max. 4.8 kg)

Right side 100°

Rear 65°

Max. 7 kg

(Max. 5.8 kg)

The figures inside ( ) are the loads when the SZX stand arm, weighing

1.2 kg, is used.

· When the mounted microscope is heavy, set the horizontal arm rotation

stopper for the front 90° positioning. (For the method of this operation,

see page 11.)

4. When the mounted microscope has a TV camera or photography unit

mounted on it, do not tilt the microscope body. As the microscope is heavy

and the center of gravity of the system is located high, loosening the clamping

lever may cause the microscope to rotate suddenly, causing damage to

the TV camera, photography unit or microscope body. (Fig. 13) (For the

method of this operation, see page 13.)

* Under this condition, the stand

tends to topple down easily if an-

other load is applied during the

microscope operation. It is rec-

ommended to set the horizontal

arm as short as possible.