Olympus U-RFLT50 Anleitung Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Laborausrüstung Olympus U-RFLT50 herunter. Olympus U-RFLT50 16 Seiten. Power supply unit
Auch für Olympus U-RFLT50: Anleitung Handbuch (36 seiten)
Seite drucken
- 1. Table of Contents
- 1. 2 Assembly
- 1. Assembly Diagram
- 1. Mounting the Mercury Burner
- 1. Setting the Voltage Selector Switch
- 1. Connecting Cords and Cables
- 2. 3 Preparation for Observation
- 2. Turning on the Mercury Burner
- 2. Centering the Mercury Burner
- 3. 4 Specifications
- 4. 5 Troubleshooting Guide
- 4. Proper Selection of the Power Supply Cord
INPORTANT
This mercury burner power supply unit is only designed for use with Olympus mercury burner light source
attachments. When using this power supply unit, always refer to the instruction manual for the CX-RFL,
CH-RFL, etc., reflected light fluorescence module.
SAFETY PRECAUTIONS
1. The applicable lamp housing is a mercury burner configuration Olympus lamp housing (U-LH50HG).
2. Always press the main switch to "
3. The power supply unit contains high voltage components. To avoid a potential shock hazard, never attempt to disassemble
the unit.
4. To avoid a potential shock hazard, be sure to ground the equipment. If the equipment is not grounded, Olympus can
no longer warrant the electrical safety and performance of the equipment.
5. The high pressure mercury burner (mercury arc lamp) should be an HBO50W/AC burner (mfd. by OSRAM) or a CS50W4
burner (mfd. by PHILIPS).
6. Before opening the lamp housing for replacement of the burner or other internal parts, press the main switch to "
(OFF) and unplug the lamp housing connecting cord plug from the output connector on the power supply unit. Allow 10
minutes or more for the burner and lamp housing to cool before touching.
7. Do not open the lamp housing while the burner is turned on or for at least 10 minutes after it is turned off. Lamp housing
parts will be extremely hot and will cause burns if touched.
8. Do not reverse the upside/down side of the lamp housing or mount it in a tilted position. The surfaces of the lamp
housing will become extremely hot during operation. When installing the microscope, make sure to allow ample free
space around and in particular above and below the lamp housing.
9. Always follow national and local laws when discarding a mercury burner.
10. The attachment should only be covered with the dust cover after the lamp housing has cooled and the power cord has
been disconnected from the wall outlet.
11. Always use the power cord provided by Olympus. If on power cord is provided, please select the proper power cord by
referring to the section "PROPER SELECTION OF THE POWER SUPPLY CORD" at the end of this instruction manual. If the
proper power cord is not used, Olympus can no longer warrant the electrical safety and performance of the equipment.
12. The power supply's built-in lithium battery (for the burner life time hour counter) should be replaced by your Olympus
representative. When disposing of the power supply, always follow national and local laws and guidelines for disposal
of equipment with built-in lithium batteries.
" (OFF) before connecting/disconnecting the power cord to/from the wall outlet.
i
"