ARC ZBCMR-300 Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Handbuch für Empfänger ARC ZBCMR-300 herunter. ARC ZBCMR-300 10 Seiten. Zigbee dimmer module receiver

Issue Date: 18/04/2022

AIRING

2 Ways of pairing.

Join Mode - ZigBee Network Pairing through Coordinator or Hub

1. Remove the device from previous ZigBee network if it has already been

added to, otherwise pairing will fail. (please refer to "Factory Reset Manually)

2. From your ZigBee Controller or hub interface, choose to add module

receiver and enter Pairing mode as instructed by the controller.

3. Power ON module receiver, LED on module will flash green every 5 seconds,

once connection is successful, connected output will flash twice to confirm.

4. Note that there is a 1 minute timeout, so to enter Join Mode again or

manually exit Join Mode to Standby Mode simply press the 'join' button

once.

5. Once module receiver is connected, it will appear in your controller's menu

and can be controlled through controller or hub interface.

TouchLink with a ZigBee Remote

1. Should not be in any network of Zigbee coordinator or hub.

2. With the module receiver in Standby Mode, bring the remote within 10cm of

module receiver.

3. Set the remote into TouchLink commissioning, please refer to the

corresponding remote manual to operate.

4. There shall be an indication on the remote for successful link and at the

same time connected output will flash twice to confirm.

PAIRING / FACTORY RESET

4. Pairing / Factory Reset