ARC ZBCMR-300 Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Empfänger ARC ZBCMR-300 herunter. ARC ZBCMR-300 10 Seiten. Zigbee dimmer module receiver

Issue Date: 18/04/2022

5. Trailing & Leading Edge / Filament LED Mode

Initial factory pre-set is at 'Trailing Edge'.

Depending on the output you are using, please use the appropriate setting.

To change between the 3 modes, please follow below setup.

Switch in-between Trailing & Leading Edge / Filament LED bulb Mode

LED on module will flash:

⚫

Leading Edge: Red LED once.

⚫

Trailing Edge: Red LED twice.

⚫

Filament LED bulb Mode: Red LED 3 times.

1. With the module receiver in Standby Mode and output in OFF status.

2. Short press "mode" button each time to change mode.

3. Default cycle from Trailing edge → Filament LED bulb → Leading edge →

Trailing edge and so on...

4. Once you have decided the mode, hold down 'mode' button for over 5

seconds until red LED flash then release button. This will confirm the setup

is complete.

6. Minimum Brightness Level Setup

There are total 4 level brightness to choose from.

To adjust the brightness level, please follow below setup.

1. Turn output on at 100% brightness.

2. Hold down 'join' button for 3 seconds, output will be at the 4

3. Short press 'join' button again to switch minimum brightness level.

4. Minimum brightness level will cycle from 4 → 3 → 2 → 1 → 2 → 3 → 4 and

so on...

5. Once you have decided the suitable minimum brightness level, hold down

'join' button for 3 seconds, connected output will flash twice to confirm.

TRAILING & LEADING EDGE / FILAMENT LED BULB MODE SETUP

MINIMUM BRIGHTNESS LEVEL SETUP

Setup

highest level.