Arc-Zone DGP-PG3-A Betriebshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Schweißen System Arc-Zone DGP-PG3-A herunter. Arc-Zone DGP-PG3-A 11 Seiten. Heavy-duty tungsten grinder

Seite drucken

NJUMMJVQQJOOQP=

ïïïK~êÅJòçåÉKÅçã=

máê~åÜ~=fff=léÉê~íáçåë=j~åì~äW=m~ÖÉ=S=

SETTING THE TIP FLAT GAUGE:

Note: The left gauge hole is for 3/32" diameter and smaller electrodes and the right

gauge hole is for electrodes larger than 3/32" in diameter.

With electrode extending to the desired length, tighten the electrode wand.

Loosen Nut D on the Tip Flat Gauge

and insert electrode into the Tip Flat

Gauge.

Rotate Knob C until the Stop makes

contact with the electrode tip, then lock

in place with

Nut D.

To duplicate electrode Tip Flat

diameter, insert electrode into

electrode wand. Extension should be beyond the desired final length.

Adjust electrode wand so there is a slight drag on the extended electrode.

Insert electrode into Tip Flat Gauge and slide until the nose of the electrode wand

contacts the Gauge face. Secure electrode into position by tightening the electrode

wand.

GRINDING:

After the set up procedure, you are now ready to prepare precision ground tungsten

electrodes quickly and easily. Turn Power Switch On: Insert tungsten into the proper

Collet Hole in the Universal Collet.

Lightly contact the wheel with the tungsten and rotating the electrode in a steady

manner until you achieve the desired Grind Angle or Tip-Flat. Be patient and Do Not

gouge or force the electrode into the wheel by trying to grind the electrode too quickly.

Gouging the electrode into the wheel causes excessive wheel wear and inconsistent

electrode finish.

^o`JwlkbK`ljI=fåÅ.

==OMVN=i~ë=m~äã~ë=aêáîÉ=píÉK=`

==`~êäëÄ~ÇI=`^==VOMNNJNRRN=

qÉäW=TSMKVPNKNRMM

==UMMKVQQKOOQP

==c~ñW=TSMKVPNKNRMQ

==bJj~áäW=áåÑç]~êÅJòçåÉKÅçã==

ïïïK~êÅJòçåÉKÅçã=