Arcam SOLO MINI Handbuch - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Medienkonverter Arcam SOLO MINI herunter. Arcam SOLO MINI 18 Seiten. Music system
Auch für Arcam SOLO MINI: Broschüre (2 seiten), Handbuch (20 seiten)
positioning
Positioning the unit
Place Solo Mini on a level, firm surface, avoiding
<
direct sunlight and sources of heat or damp.
Do not place Solo Mini on top of a power
<
amplifier or other source of heat.
Do not place Solo Mini in an enclosed space such
<
as a bookcase or closed cabinet unless there
is good provision for ventilation. Solo Mini is
designed to run warm during normal operation.
Do not place any other component or item on
<
top of Solo Mini as this may obstruct airflow
around and through the unit, causing Solo Mini to
overheat.
Do not obstruct the vents in the top, bottom, or
<
sides of Solo Mini.
Make sure the remote-control receiver on the
<
left-hand side of the display is unobstructed,
otherwise the remote control will not work
reliably.
Power
Solo Mini is supplied with a moulded mains plug already
fitted to the lead. Check that the plug supplied fits your
supply – should you require a new mains lead, please
contact your Arcam dealer.
Push the IEC plug end of the power cable into the
socket on the back of Solo Mini, making sure that it is
pushed in firmly. Plug the other end of the cable into
your mains socket and, if necessary, switch the socket
on.
Solo Mini is fitted with a power switch on the rear
panel, below the power inlet: make sure that this is
switched on.
Solo Mini is fitted with a transformer designed to
accept the mains voltage in the region that the product
was shipped to. If your mains supply voltage does not
match the specification printed on the rear panel, or
you wish to take the unit to a region with a different
mains voltage, or the mains plug is incorrect, please
contact your Arcam dealer.
7
Thermal protection
Make sure that the unit receives adequate ventilation at
all times (see 'Positioning the unit').
If Solo Mini gets too hot, an 'Over Temperature'
warning is shown on the front panel and the unit shuts
down to protect itself. You can restart Solo Mini after it
has cooled for 15 minutes without power.
Interconnect cables
We recommend the use of high-quality screened cables
that are designed for the particular application. All
cables should be kept as short as is practically poss ble.
To avoid unwanted noise in the audio signals, make sure
that the mains power-supply cabling is kept as far away
as possible from your audio cables.