- ページ 7

メディア・コンバーター Arcam SOLO MINIのPDF ハンドブックをオンラインで閲覧またはダウンロードできます。Arcam SOLO MINI 18 ページ。 Music system
Arcam SOLO MINI にも：パンフレット (2 ページ), ハンドブック (20 ページ)

ページを印刷する

positioning

Positioning the unit

Place Solo Mini on a level, firm surface, avoiding

direct sunlight and sources of heat or damp.

Do not place Solo Mini on top of a power

amplifier or other source of heat.

Do not place Solo Mini in an enclosed space such

as a bookcase or closed cabinet unless there

is good provision for ventilation. Solo Mini is

designed to run warm during normal operation.

Do not place any other component or item on

top of Solo Mini as this may obstruct airflow

around and through the unit, causing Solo Mini to

overheat.

Do not obstruct the vents in the top, bottom, or

sides of Solo Mini.

Make sure the remote-control receiver on the

left-hand side of the display is unobstructed,

otherwise the remote control will not work

reliably.

Power

Solo Mini is supplied with a moulded mains plug already

fitted to the lead. Check that the plug supplied fits your

supply – should you require a new mains lead, please

contact your Arcam dealer.

Push the IEC plug end of the power cable into the

socket on the back of Solo Mini, making sure that it is

pushed in firmly. Plug the other end of the cable into

your mains socket and, if necessary, switch the socket

on.

Solo Mini is fitted with a power switch on the rear

panel, below the power inlet: make sure that this is

switched on.

Solo Mini is fitted with a transformer designed to

accept the mains voltage in the region that the product

was shipped to. If your mains supply voltage does not

match the specification printed on the rear panel, or

you wish to take the unit to a region with a different

mains voltage, or the mains plug is incorrect, please

contact your Arcam dealer.

Thermal protection

Make sure that the unit receives adequate ventilation at

all times (see 'Positioning the unit').

If Solo Mini gets too hot, an 'Over Temperature'

warning is shown on the front panel and the unit shuts

down to protect itself. You can restart Solo Mini after it

has cooled for 15 minutes without power.

Interconnect cables

We recommend the use of high-quality screened cables

that are designed for the particular application. All

cables should be kept as short as is practically poss ble.

To avoid unwanted noise in the audio signals, make sure

that the mains power-supply cabling is kept as far away

as possible from your audio cables.