Digilent Basys 2 Referenzhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Referenzhandbuch für Computer Hardware Digilent Basys 2 herunter. Digilent Basys 2 12 Seiten. Fpga board

Seite drucken

Basys2™ FPGA Board Reference Manual

Common anode

AN1

AN2

AN3

AN4

CA CB CC CD CE CF CG DP

Four-digit Seven

Segment Display

For each of the four digits to appear bright and continuously illuminated, all four digits should be driven once every

1 to 16ms (for a refresh frequency of 1KHz to

60Hz). For example, in a 60Hz refresh scheme,

the entire display would be refreshed once every

16ms, and each digit would be illuminated for ¼

of the refresh cycle, or 4ms. The controller must

assure that the correct cathode pattern is

present when the corresponding anode signal is

driven. To illustrate the process, if AN1 is

asserted while CB and CC are asserted, then a

"1" will be displayed in digit position 1. Then, if

AN2 is asserted while CA, CB and CC are

asserted, then a "7" will be displayed in digit

position 2. If A1 and CB, CC are driven for 4ms, and then A2 and CA, CB, CC are driven for 4ms in an endless

succession, the display will show "17" in the first two digits. Figure 8 shows an example timing diagram for a four-

digit seven-segment controller.

PS/2 Port

The 6-pin mini-DIN connector can accommodate a PS/2 mouse or keyboard. The PS/2 connector is supplied with

5VDC.

Both the mouse and keyboard use a two-wire serial bus (clock and data) to communicate with a host device. Both

use 11-bit words that include a start, stop and odd parity bit, but the data packets are organized differently, and

the keyboard interface allows bi-directional data transfers (so the host device can illuminate state LEDs on the

keyboard). Bus timings are shown in the figure.

The clock and data signals are only driven when data transfers occur, and otherwise they are held in the "idle"

state at logic '1'. The timings define signal requirements for mouse-to-host communications and bi-directional

keyboard communications. A PS/2 interface circuit can be implemented in the FPGA to create a keyboard or

mouse interface.

Other product and company names mentioned may be trademarks of their respective owners.

Individual cathodes

Figure 7. Seven-segment display.

AN0

AN1

AN2

AN3

Cathodes

An un-illuminated seven-segment display, and nine

illumination patterns corresponding to decimal digits

Refresh period = 1ms to 16ms

Digit period = Refresh / 4

Digit 0

Digit 1

Digit 2

Figure 8. Multiplexed 7seg display timing.

Digit 3

Page 5 of 12