Digilin Colour Theme 1 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Beleuchtungsanlagen Digilin Colour Theme 1 herunter. Digilin Colour Theme 1 8 Seiten. Single channel dmx dimmer

Seite drucken

Colour Theme 1 - Single Channel DMX Dimmer

User Manual

7.1 - 17 September 2020

Storing Default Setting

Storing a default setting will set which colour temperature and dim level the Colour Theme Controller will

load when first power on (the factory default colour temperature is 3000K). To change this, with the unit

turned on, select the desired show and dim level. Next press and hold the knob for a period of 2.5 seconds.

The display will cycle to the dim setting, and then the unit will briefly flash to off. Once the unit is back on,

the setting is saved.

Serial Interface

The Colour Theme Controller features an RS232 serial interface with the following data format:

•

9600 baud

•

8 bit data

•

1 stop bit

•

No parity

•

No flow control

The pin-out for the RJ45 connector is covered in Appendix A RS232 Null Modem Cables using RJ45

Connectors.

User Configuration

Configuration mode allows the user to change various settings (as listed in Table 1). To use this mode, the

Colour Theme Controller will need to be connected to a computer running a terminal program

with the settings from above), via the RJ45 serial connection. Before power up, place a jumper on the pins

of JP1 (refer to Figure 1).

Once the Colour Theme Controller is powered up, it should print a menu like that shown in Figure 2 in the

terminal program window. To alter settings, simply follow the instructions in the menu (settings are saved

automatically as they are altered). To exit configuration mode, power off the Colour Theme Controller and

remove the jumper on JP1.

S e t t i n g

DMX Start Address

Channel Repeat

Echo enabled

Table 1 Settings in User Configuration.

Figure 2 Starting menu in configuration mode.

Up until Windows Vista, the terminal program HyperTerminal was installed as part of a windows installation. A simple

web search will turn up a number of free alternatives for use with newer operating systems.

digilin.com.au

+617 3899 1267

D e s c r i p t i o n

Channel to start the RGB triplet (all address before

this will transmit as 0)

Number of times to repeat the RGB triplet

Controls if commands are sent back (echoed) to the

user when sending serial commands

Digilin Colour Theme Controller V3

Software Version 2.3

User Configuration

1. Set DMX Start Address

2. Set Times to repeat Channel

3. Enable/Disable Echo in Serial Command String Mode

Enter your Selection

(configured

D e f a u l t

V a l i d R a n g e

V a l u e

1 – 510

1 - 512

On/Off

Yes

Page 5 of 8