Digilin Colour Theme 1 Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di illuminazione Digilin Colour Theme 1. Digilin Colour Theme 1 8. Single channel dmx dimmer
Stampa la paginaColour Theme 1 - Single Channel DMX Dimmer
User Manual
7.1 - 17 September 2020
Storing Default Setting
Storing a default setting will set which colour temperature and dim level the Colour Theme Controller will
load when first power on (the factory default colour temperature is 3000K). To change this, with the unit
turned on, select the desired show and dim level. Next press and hold the knob for a period of 2.5 seconds.
The display will cycle to the dim setting, and then the unit will briefly flash to off. Once the unit is back on,
the setting is saved.
Serial Interface
The Colour Theme Controller features an RS232 serial interface with the following data format:
•
9600 baud
•
8 bit data
•
1 stop bit
•
No parity
•
No flow control
The pin-out for the RJ45 connector is covered in Appendix A RS232 Null Modem Cables using RJ45
Connectors.
User Configuration
Configuration mode allows the user to change various settings (as listed in Table 1). To use this mode, the
Colour Theme Controller will need to be connected to a computer running a terminal program
with the settings from above), via the RJ45 serial connection. Before power up, place a jumper on the pins
of JP1 (refer to Figure 1).
Once the Colour Theme Controller is powered up, it should print a menu like that shown in Figure 2 in the
terminal program window. To alter settings, simply follow the instructions in the menu (settings are saved
automatically as they are altered). To exit configuration mode, power off the Colour Theme Controller and
remove the jumper on JP1.
S e t t i n g
DMX Start Address
Channel Repeat
Echo enabled
Table 1 Settings in User Configuration.
Figure 2 Starting menu in configuration mode.
1
Up until Windows Vista, the terminal program HyperTerminal was installed as part of a windows installation. A simple
web search will turn up a number of free alternatives for use with newer operating systems.
digilin.com.au
+617 3899 1267
D e s c r i p t i o n
Channel to start the RGB triplet (all address before
this will transmit as 0)
Number of times to repeat the RGB triplet
Controls if commands are sent back (echoed) to the
user when sending serial commands
Digilin Colour Theme Controller V3
Software Version 2.3
User Configuration
1. Set DMX Start Address
2. Set Times to repeat Channel
3. Enable/Disable Echo in Serial Command String Mode
Enter your Selection
1
(configured
D e f a u l t
V a l i d R a n g e
V a l u e
1 – 510
1
1 - 512
1
On/Off
Yes
Page 5 of 8